When we use a small concrete mixer, we may encounter the phenomenon that the mixer jar is stuck, and then causes the phenomenon of rotation immobility. Then what should we do when we encounter this phenomenon? Let's take a look at the solution to it.

　　1、檢查一下液壓油是否漏光了(管子壞了換管子，密封件壞了換密封件）。

　　1. Check whether the hydraulic oil leaks completely (replace the pipe if the pipe is broken, and replace the seal if the seal is broken).

　　2、檢查一下散熱器風扇在轉沒有，液壓油乳化變白沒有，液壓油溫度超過90度，液壓系統就沒有壓力，罐子就不轉了。這種情況不要著急，用水冷卻一下液壓泵，液壓馬達，液壓油溫度下來，罐子就可以轉動了。把料放出來，趕緊修理散熱器或更換液壓油。

　　2. Check whether the radiator fan is running, whether the hydraulic oil emulsion turns white, if the hydraulic oil temperature exceeds 90 degrees, the hydraulic system will not have pressure, and the tank will not rotate. Don't worry about this situation. Cool down the hydraulic pump, hydraulic motor and hydraulic oil with water. When the temperature of the hydraulic oil comes down, the tank can rotate. Put the material out and repair the radiator or change the hydraulic oil.
               

　　3、攪拌運輸中沒有注意，罐子停了，混凝土塌住了，罐子翻不過去。感覺有壓力能轉一點就可能是這種情況。

　　3. During mixing and transportation, the tank stopped, the concrete collapsed, and the tank could not turn over. If you feel pressure to turn a little bit, this may be the case.

　　4、動軸十字節損壞，斷了。斷了立即更換一根傳動軸，傳動軸用好的。

　　4. The cross section of moving shaft is damaged and broken. If it is broken, replace a transmission shaft immediately. The transmission shaft is in good condition.

　　5、壓泵損壞了情況復雜一點，內瀉嚴重。

　　5. The pressure pump is damaged. The situation is more complicated and the internal leakage is serious.

　　看完上述內容后，我們?cè)儆龅叫⌒突炷翑嚢铏C(jī)罐子不轉了的時候，不要驚慌，堅持一個原則，不要讓混凝土凝結在罐子里，要把混凝土放出來，就可以從容處理攪拌機的故障。

　　After reading the above contents, we should not panic when the small concrete mixer pot does not rotate. We should adhere to the principle that the concrete should not be condensed in the tank. If we want to release the concrete, we can handle the failure of the mixer calmly.