混凝土攪拌機使用前的準備工作有哪些？
來源：http://www.wishnailspa.com/日期：2021-05-27
概述：混凝土攪拌機使用前的準備工作主要有以下幾個方面：The preparation work before using concrete mixer mainly includes the fol
混凝土攪拌機使用前的準備工作主要有以下幾個方面：
The preparation work before using concrete mixer mainly includes the following aspects:
1、檢查混凝土攪拌機各部連接螺栓是否松動，如有松動應予緊固；
1. Check whether the connecting bolts of each part of the concrete mixer are loose, and tighten them if they are loose;
2、電動機部分，按通用操作規程的有關規定執行；
2. The motor part shall comply with the relevant provisions of the general operating procedures;
3、檢查給混凝土攪拌機電源電壓是否同設備所需工作電壓相匹配，其大大允許偏差為±5%；
3. Check whether the power supply voltage of the concrete mixer matches the working voltage required by the equipment, and the maximum allowable deviation is ± 5%；
4、根據生產要求，確定調整混凝土攪拌機設備各種裝置的運行參數；
4. According to the production requirements, determine and adjust the operation parameters of various devices of concrete mixer equipment;
5、檢查漏電保護裝置是否可靠有效。
5. Check whether the leakage protection device is reliable and effective.
6、檢查混凝土攪拌機有無異響，旋轉方向是否正確，出料門的關閉和開啟是否嚴密和到位；
6. Check whether the concrete mixer has abnormal sound, whether the rotation direction is correct, and whether the discharge door is closed and opened tightly and in place;
7、檢查空氣壓縮機有無異響和漏氣現象，壓縮空氣的壓力保持在0.7Mpa左右的范圍內時方能使用氣動設備；
7. Check the air compressor for abnormal noise and air leakage, and use the pneumatic equipment only when the pressure of compressed air is kept within 0.7MPa;
8、檢查進料皮帶托輥是否完好、皮帶是否跑偏，料倉平皮帶運轉是否正常；
8. Check whether the feeding belt idler is in good condition, whether the belt deviates, and whether the silo flat belt runs normally;
9、檢查水的壓力，水的清潔度和流量是否合乎標準；
9. Check whether the water pressure, cleanliness and flow meet the standard;
10、檢查稱量裝置是否完好準確；
10. Check whether the weighing device is in good condition and accurate;
11、將設備上所有儀表的指針調到“0”位；
11. Set the pointer of all instruments on the equipment to "0";
12、為確保振動器的冷卻，必須及時振動器表面聚積的塵土，并檢查其電纜有無損傷；
12. In order to ensure the cooling of the vibrator, the accumulated dust on the surface of the vibrator must be removed in time, and the cable must be checked for damage;
13、經檢查或停機時間較長的設備，要重新投入使用時，須先經模擬生產程序手動空轉試車，確認正常后，方可進行生產；
13. If the equipment that has been inspected or has been shut down for a long time needs to be put into use again, it must first go through the manual idling test run of the simulated production program and confirm that it is normal before production can be carried out;
為延長混凝土攪拌機的使用壽命，以上十三條注意事項一定要重視！
In order to extend the service life of concrete mixer, we must pay attention to the above 13 points for attention!
全國服務熱線
點擊撥打服務熱線：400-879-1999
