1： Operation operation

1、需進行攪拌的混合物應嚴格參照規定值，勿隨意超過。

1. The mixture to be stirred shall strictly refer to the specified value and shall not exceed it at will.

2、傳動裝置、攪拌裝置等內部件按照規定加足潤滑油。

2. Add enough lubricating oil to internal parts such as transmission device and mixing device according to regulations.

3、使用前檢查震動部件和與之連接部分是否緊固，接地線，各線路，供水裝置等是否正常。

3. Before use, check whether the vibrating parts and their connecting parts are fastened, and whether the grounding wires, lines, water supply devices, etc. are normal.

4、檢查攪拌葉片有無松動，非正常磨損。

4. Check the mixing blade for looseness and abnormal wear.

5、空轉能否正常進行，電機，減速器等設備噪音是否異常。

5. Whether idling can be carried out normally, and whether the noise of motor, reducer and other equipment is abnormal.

6、攪拌機使用過程中加料順序應合理科學促進攪拌物勻質，操作環境應保持清潔，卸料時供水應及時。

6. During the use of the mixer, the feeding sequence shall be reasonable and scientific to promote the uniformity of the mixture, the operating environment shall be kept clean, and the water supply shall be timely during unloading.

7、正確操作攪拌機，發現異常應立即停機。

7. Operate the mixer correctly and shut down immediately in case of any abnormality.

二：使用后的清潔

2： Cleaning after use

設備工作完畢，應認真清理機體內外，尤其是操作時塵土嚴重的環境。停機前，加入一定比例水石反復攪拌，清理內部余積。仔細沖洗機體外部附著物以及卸料門周圍堆積物。

After the equipment is completed, carefully clean the inside and outside of the machine body, especially the dusty environment during operation. Before shutdown, add a certain proportion of water stone for repeated mixing to clean up the internal residue. Carefully wash the external attachments of the machine body and the deposits around the discharge door.

三：定期保養

3： Regular maintenance

1、為避免外加劑的投料管路堵塞，需定期清理。

1. In order to avoid the blockage of the feeding pipeline of the admixture, it needs to be cleaned regularly.

2、易損件定期檢查，及時更換。

2. Vulnerable parts shall be inspected regularly and replaced in time.

3、為保證液壓泵站正常運行工作，定期更換液壓油。

3. In order to ensure the normal operation of the hydraulic pump station, the hydraulic oil shall be replaced regularly.

4、定期拆檢清洗攪拌機件，檢查磨損程度，影響設備使用的部件，應予更換。

4. Regularly disassemble, inspect and clean the mixer parts, check the wear degree, and replace the parts that affect the safe use of the equipment.

5、檢查校正制動間隙，上料斗和卸料靈活情況和密閉性。

5. Check and correct the brake clearance, the flexibility and tightness of loading hopper and unloading.

6、檢查攪拌葉片和傳動裝置靈活度。

6. Check the flexibility of mixing blades and transmission.

7、檢查水路系統，電路情況。

7. Check the waterway system and circuit.

以上就是今天小編帶給大家的精彩內容，混凝土攪拌機將不斷深化自身的實力，不斷的提高質量，做好價格公正，歡迎大家在網站上點擊購買：http://www.wishnailspa.com

The above is the wonderful content brought to you by today's Xiaobian. The concrete mixer will continue to deepen its own strength, continuously improve its quality and do a good job in price justice. You are welcome to click to buy on the website: http://www.wishnailspa.com