檢查前，自動上料攪拌機需準備好駕照、駕駛證、保險單、年檢所需費用。攪拌機到達現場后需填寫年檢申請表，年檢申請表應由運輸部門蓋章，加蓋單位公章或私自簽名，并附身份證復印件。如果有違規記錄，我們必須處理。不要根據自己的喜好改裝車身外觀（不能隨意更換汽車外殼或發動機，也不能購買來歷不明的汽車）。否則，它將無法通過外觀。

Before the inspection, the driver's license, driver's license, insurance policy and annual inspection fees shall be prepared for the automatic feeding mixer. After the mixer arrives at the site, it is required to fill in the annual inspection application form, which shall be sealed by the transportation department, stamped with the official seal of the unit or signed privately, and attached with a copy of the ID card. If there is a violation record, we must deal with it. Don't modify the appearance of the car body according to your own preferences (you can't replace the car shell or engine at will, and you can't buy a car of unknown origin). Otherwise, it will not pass through the appearance.

下一步是檢查。前后軸負載、腳剎、手剎、懸架、側滑等都能用準確的數據顯示您的混音器是否合格，還有燈光、大燈亮度等角度等，如果某一項不合格，可以在規定時間內復查。當然，復查需要分開支付。

The next step is safety inspection. Front and rear axle load, foot brake, hand brake, suspension, side slip, etc. can use accurate data to show whether your mixer is qualified, as well as the angle of light, headlight brightness, etc. if one item is unqualified, it can be rechecked within the specified time. Of course, the review needs to be paid separately.

此外使用后要記得保養，清理攪拌機內外，料門上的積料，并沖洗干凈；放盡空壓機貯氣筒內的氣體和積水；各潤滑點加注潤滑點，尤其是軸端密封處，切不可遺漏；冬季應放凈水路內的液體；停機后所有開關處于非工作狀態，并切斷電源。

In addition, remember to maintain the mixer after use, clean the accumulated materials inside and outside the mixer and on the material door, and wash them thoroughly; Drain the gas and water in the air compressor air reservoir; The lubricating points shall be filled at each lubricating point, especially at the shaft end seal, and shall not be omitted; Discharge the liquid in the waterway in winter; After shutdown, all switches are in non working state and the power supply is cut off.

3月內檢查保養：檢查皮帶的張緊情況，并作適當?shù)恼{(diào)整；檢查葉片，襯板的磨損情況；檢查上、下機架，料倉，大斜皮帶機等部件的連接螺栓是否牢固，地基是否下沉；檢查螺栓輸送機內是否有結塊和雜物，如有則。

Inspection and maintenance within 3 months: check the belt tension and make appropriate adjustment; Check the wear of blades and lining plates; Check whether the connecting bolts of the upper and lower frames, silos, large inclined belt conveyor and other components are firm and whether the foundation sinks; Check whether there are lumps and sundries in the bolt conveyor, and remove them if any.

4周內檢查保養：檢查自動上料攪拌機攪拌罐內殘留砼的凝結情況，如有凝結應停機進行鏟除（注意應切斷電源專人看護），檢查攪拌葉片與襯板間隙，如不適合進行調整；檢查各電器元件是否有損壞現象，必要時修理或更換，檢查各接線是否松動；檢查減速箱內的潤滑油的質量和液面高度，必要時加注或更換；檢查供水系統中吸水底閥是否可靠；檢查氣路系統是否漏氣，氣缸動作是否可靠；擰開放淤塞，檢查軸端密封情況，無異常后在擰入放淤塞。

Inspection and maintenance within 4 weeks: check the condensation of the residual concrete in the mixing tank of the automatic feeding mixer. If there is any condensation, shut down the machine for eradication (note that the power supply should be cut off and watched by a specially assigned person), check the gap between the mixing blade and the lining plate, and adjust it if it is not suitable; Check whether the electrical components are damaged, repair or replace them if necessary, and check whether the wiring is loose; Check the quality and liquid level of lubricating oil in the reduction gearbox, and fill or replace it if necessary; Check whether the suction bottom valve in the water supply system is reliable; Check whether the air circuit system leaks and whether the cylinder operates reliably; Screw in and remove the blockage, check the sealing condition of the shaft end, and screw in and remove the blockage after there is no abnormality.

5年檢和大修：設備運行運行一年，除了對1、2、3、4項進行檢查外，還應對自動上料攪拌機其他部件進行檢查，進行檢查維修和更換。

5 annual inspection and overhaul: after the equipment has been operated for one year, in addition to the inspection of items 1, 2, 3 and 4, other parts of the automatic feeding mixer shall also be inspected for comprehensive inspection, maintenance and replacement.

希望以上所講可以幫助到您，更多相關的信息您可以來關注我們網站http://www.wishnailspa.com，聯系客服人員，為您講解更多更為詳細的內容或者問題，讓您在此有所獲?。?/div>