混凝土攪拌機在冬季低溫環境下不易啟動，一直是廣大朋友們共同面臨的難題。今天，小編就低溫啟動常見的一些誤區給大家做一個盤點，相信對于經驗豐富的朋友們，會是一次溫故知新，對于了解不多的朋友們，將會是一筆寶貴的經驗。

The concrete mixer is not easy to start under the low temperature environment in winter, which has been a common problem faced by many friends. Today, I will make an inventory of some common mistakes in low temperature startup. I believe that it will be a valuable experience for experienced friends to review the past and learn the new.

打不著火連續啟動

Continuous start without ignition

冬季車輛電瓶耗電量較大，電瓶在晚上停車之后一般還會放電，啟動時打不著火，連續啟動更會損壞電瓶。建議朋友們在停車之前及時關閉耗電裝置，再關閉發動機。車輛在啟動發動機預熱后再打開空調、收音機，以延長電瓶壽命。

In winter, the battery of the vehicle consumes a lot of electricity. The battery will generally discharge after parking at night. The battery will not catch fire when starting. Continuous starting will damage the battery even more. It is recommended that friends turn off the power consumption device in time before parking, and then turn off the engine. After the vehicle is warmed up by starting the engine, turn on the air conditioner and radio to extend the battery life.

啟動后猛踩幾腳油門

After starting, step on the accelerator

不少攪拌機司機在冬季車輛啟動后，會猛踩幾腳油門，這其實對車輛有嚴重的損傷：1、這樣不但耗油，而且會加劇發動機的磨損。2、容易導致濾芯膨脹，甚脹破?？傊?，冷啟動后猛踩油門對發動機的各項性能有百害而無一利。正確的操作是在發動機的溫度升高到40攝氏度以后再適當加油門。

Many blender drivers will step on the accelerator several times after the vehicle starts in winter, which actually causes serious damage to the vehicle: 1. This not only consumes fuel, but also increases the wear of the engine. 2. It is easy to cause the filter element to expand or even burst. In a word, stepping on the accelerator after a cold start is harmful to the performance of the engine. The correct operation is to increase the temperature of the engine to 40 ℃ before the proper fuel valve.

過分依賴啟動液

Excessive dependence on starting fluid

車子在戶外放置時間過久，發動機各摩擦部件之間都會出現無潤滑油情況，各摩擦部件表面都處于干摩擦狀態。此時若用冷啟動液助啟動的話，發動機頓時點火產生很大沖擊力，必定磨損量很大，若噴的啟動液過多還會造成冷拉缸或燒瓦事故。

If the car is left outdoors for too long, there will be no lubricating oil between the friction parts of the engine, and the surfaces of the friction parts are in a dry friction state. At this time, if the cold starting fluid is used to assist the starting, the engine will immediately ignite and produce a great impact, which will certainly cause great wear. If too much starting fluid is sprayed, it will also cause cold cylinder drawing or bush burning accidents.

正確方法應該是在使用冷啟動液之前，對油箱和油底殼進行一定的預熱，使發動機內各運動部件得到良好潤滑，安裝油箱加熱器進行預熱，可以使用噴燈進行加熱但不建議使用明火，畢竟明火存在很大的隱患。

The correct method should be to preheat the oil tank and oil pan to a certain extent before using the cold starting liquid, so that all moving parts in the engine can be well lubricated. Install the oil tank heater for preheating. You can use a blowtorch for heating, but it is not recommended to use an open flame. After all, open flame has a great potential safety hazard.

無論哪種發動機在寒冷的冬天難免遇到發動困難的情況，越是到這種時候就越應該避免魯莽操作，養成良好習慣，對自己的愛車負責，是作為一名合格攪拌機司機的必備條件。更多相關內容就來我們網站http://www.wishnailspa.com咨詢吧！

No matter what kind of engine is difficult to start in cold winter, the more this time comes, the more you should avoid reckless operation, develop good habits, and be responsible for your car, which is a prerequisite for a qualified mixer driver. More relevant content will come to our website http://www.wishnailspa.com Consult!