Automatic feeding mixer has a good market value, now the scope of use is more and more widely, of course, the use of a long time can not avoid all kinds of failure problems, but some failures are caused by symptoms before appearing. Let's take a look.

　　異響。如果自動上料攪拌機行駛過程中出現異響，應立即下車檢查，或到維修點排除故障，切不可讓攪拌車“帶病工作”。萬一在路上發生事故，對施工和本身都會造成不小的影響。

　　Sound. If there is abnormal sound in the driving process of the automatic feeding mixer, it should be checked immediately, or go to the professional maintenance point to troubleshoot, and must not let the mixer "work with illness". In case of accidents on the road, the construction and itself will cause no small impact.

　　工作狀態異常。工況是指攪拌車在行駛或攪拌混凝土?xí)r出現的異?，F(xiàn)象。這些現象包括發動機突然熄火后難以啟動或無法啟動；運轉中發動機功率突然降低，或剎車失靈或跑偏等。此類故障比較明顯，更容易發現。

　　The working status is abnormal. Working condition refers to the abnormal phenomenon that appears when the mixer is driving or mixing concrete. These phenomena include the difficulty or inability to start the engine after sudden flameout; Operation of the engine power suddenly reduced, or brake failure or deviation. This type of fault is obvious and easy to detect.

　　漏液。泄漏的液體主要包括發動機燃油、制動液（壓縮空氣）和動力轉向液的泄漏。仔細觀察這個故障也可以發現。當漏氣時，可以聽到明顯的漏氣聲。

　　Leakage. The leaking fluids mainly include engine fuel, brake fluid (compressed air) and power steering fluid leakage. This failure can also be found by careful observation. When air leaks, a distinct sound of air leakage can be heard.

　　高溫過熱。高溫過熱主要發生在攪拌車發動機、變速器、制動器等設備上。如果發動機過熱，多為冷卻系統有問題，冷卻液不足或泵不工作；如果變速箱和驅動橋過熱，很可能是缺少潤滑油；如果剎車過熱，多半是剎車片不回位。以上現象無需過多分心，直接反映在儀表盤上的警示燈上即可，只要駕駛員在駕駛時注意即可。

　　Overheating. High temperature overheating mainly occurs in the engine, transmission, brakes and other equipment of the agitator car. If the engine overheats, there are problems with the cooling system, insufficient coolant or pump does not work; If the gearbox and drive axle overheat, there is likely to be a lack of lubricating oil; If the brakes overheat, most likely the brake pads do not return. The above phenomenon does not need too much distraction, directly reflected in the dashboard warning light, as long as the driver pays attention to driving.

　　排氣顏色異常。正常情況下，攪拌車發動機排放的煙霧是二氧化碳和水蒸氣。如果廢氣中含有碳?xì)浠衔?、一氧化碳和碳顆粒，廢氣會變成藍色、黑色或白色，屬于異常排氣。但是，當潤滑油向上跑氣缸時，排氣是藍色的；燃燒不完全時，廢氣為黑色，油與水混合時，廢氣為白色。

　　The exhaust color is abnormal. Normally, the fumes from the engine of the mixer are carbon dioxide and water vapor. If the exhaust gas contains hydrocarbons, carbon monoxide and carbon particles, it will turn blue, black or white, which is abnormal exhaust. However, when the lubricating oil runs up the cylinder, the exhaust is blue; When the combustion is incomplete, the exhaust gas is black, and when oil and water are mixed, the exhaust gas is white.

　　如果忽略掉以上所講解的征兆，那么將對攪拌機的行駛和工作造成很大的影響，操作人員要多加注意。當然作為一種工程車，自動上料攪拌機也需要保養，這樣才能讓設備使用時間變得更長。更多內容來網站http://www.wishnailspa.com了解吧！

　　If the above mentioned symptoms are ignored, it will have a great impact on the running and working of the mixer, so the operator should pay more attention to it. Of course, as a kind of engineering vehicle, the automatic feeding mixer also needs maintenance, so as to make the equipment longer. Come to http://www.wishnailspa.com for more information!