自上料攪拌機如何保養易損傷部位?
來源:http://www.wishnailspa.com/日期:2020-12-07
概述:混凝土攪拌機是建筑工程上主要的專用車型,保養是非常重要的,尤其是使用比較頻繁的零部件,保養好了才能增加攪拌車的使用壽命,來看看攪拌
混凝土攪拌機是建筑工程上主要的專用車型,保養是非常重要的,尤其是使用比較頻繁的零部件,保養好了才能增加攪拌車的使用壽命,來看看攪拌車的易損傷部位該怎么保養。 混凝土攪拌機易損傷部位有哪些呢?易損傷部位主要是指攪拌車上使用頻率較高的零部件,比如液壓系統,托輪,滾道,水箱,發動機等等部位。
Concrete mixer is the main special vehicle in construction engineering, maintenance is very important, especially the parts which are frequently used. Only after maintenance can the service life of mixer truck be increased. To see how to maintain the vulnerable parts of mixer truck. What are the vulnerable parts of concrete mixer? The easily damaged parts mainly refer to the parts used frequently on the mixer, such as hydraulic system, supporting roller, raceway, water tank, engine and so on.
說托輪,我們都知道 混凝土攪拌機在行駛過程中罐體是一直轉動的,這樣才能保證罐內的混凝土不凝固,不離析,罐體的轉動離不開托輪和滾道,這兩個部位一旦出問題就會造成非常嚴重的后果——混凝土凝結。所以這兩個部位的保養是長久性的,托輪和滾道之間要經常涂抹潤滑油,對于滾道上的污物要及時清理,以免影響罐體轉動。
First of all, we all know that the tank of the concrete mixer is always rotating in the process of driving, so as to ensure that the concrete in the tank does not solidify or segregate. The rotation of the tank can not be separated from the supporting wheel and the raceway. Once these two parts fail, it will cause a very serious consequence concrete condensation. Therefore, the maintenance of these two parts is long-term. Lubricating oil should be applied between the roller and the raceway. The dirt on the raceway should be cleaned up in time to avoid affecting the rotation of the tank.
混凝土攪拌機上的液壓系統也是非常重要的,攪拌罐側操作主要是依靠液壓系統來實現的,它的保養也是關重要的,比如液壓油要定期更換,不要使用劣質液壓油,對于液壓軟件要經常檢查,潤滑度不夠的要及時添加潤滑油脂,如有損傷元件要及時更換,保證液壓系統的靈活使用。
The hydraulic system on the concrete mixer is also very important. The side operation of the mixing tank mainly depends on the hydraulic system, and its maintenance is also very important. For example, the hydraulic oil should be replaced regularly, and the inferior hydraulic oil should not be used. The hydraulic software should be checked frequently. If the lubrication is insufficient, the lubricating grease should be added in time. If there is damage, the components should be replaced in time to ensure the liquid Flexible use of pressure system.
混凝土攪拌機上水箱的大小及安裝部位都是廠家經過設計師的精心設計的,所以不要隨意的改動,水箱的視水管和過濾網偶爾也要查看一下,視情況更換,以免引起堵塞,影響水位的判斷,在冬天工作完成后要及時的將水箱內的水排出,以免結冰引起水箱開裂。
The size and installation position of the water tank on the concrete mixer are carefully designed by the manufacturer through the designer, so do not change it at will. The inspection pipe and filter screen of the water tank should be checked occasionally and replaced according to the situation, so as not to cause blockage and affect the judgment of water level. After the completion of the work in winter, the water in the water tank should be discharged in time to prevent the water tank from cracking due to freezing.
發動機的使用也是非常多的,所以對發動機的保養也要注意,尤其是機油,要經常查看機油,發現機油變質要及時更換,油量變少要及時添加。對于新買的 混凝土攪拌機要注意螺栓,因?yàn)樾萝囋谑褂靡欢螘r(shí)間后各部位的螺栓容易松動,所以在使用的過程中要十分注意,發現松動螺栓及時緊固;新車的行駛速度不易過快也不易過慢,要按規定的時間進行保養。
The use of the engine is also very much, so attention should be paid to the maintenance of the engine, especially the engine oil. The engine oil should be checked frequently. If the oil deteriorates, it should be replaced in time. If the oil quantity decreases, it should be added in time. For the newly purchased concrete mixer, attention should be paid to the bolts. Since the bolts in various parts of the new car are easy to loosen after using for a period of time, great attention should be paid in the use process, and the loose bolts should be tightened in time; the driving speed of the new car is not easy to be too fast or too slow, and maintenance should be carried out according to the specified time.