日日夜夜天天,亚洲av永久无码精品放毛片,熟女少妇丰满一区二区,狠狠人妻777

歡迎您訪問萊州聚峰機械有限公司網站!
點擊撥打服務熱線:400-879-1999
大家都在搜: 鏟斗外翻 3.5噸A后側 3.5噸A后尾

攪拌機混合器軸端浮動密封件損壞怎么辦?

來源:http://www.wishnailspa.com/日期:2021-03-02

概述:混凝土攪拌機系列的攪拌軸端是組合密封型,由多層密封件如橡膠密封件和鋼密封件組成。 密封的質量影響整個混合站的全體性能。 因而,挑選
混凝土攪拌機系列的攪拌軸端是組合密封型,由多層密封件如橡膠密封件和鋼密封件組成。 密封的質量影響整個混合站的全體性能。 因而,挑選良好的密封非常重要。 混合器軸端泄漏的根本原因是浮動密封件損壞。 由于密封和油封損壞,光滑體系缺油,導致滑動輪轂和旋轉輪轂?zāi)p。
The mixing shaft end of concrete mixer series is a combined seal type, which is composed of multi-layer seals such as rubber seal and steel seal. The quality of sealing affects the overall performance of the whole mixing station. Therefore, it is very important to choose a good seal. The root cause of mixer shaft end leakage is the damage of floating seal. Due to the damage of seal and oil seal, the smooth system is short of oil, which leads to the wear of sliding hub and rotating hub.
由于軸端泄漏和與拌和軸沖突引起的軸承磨損,軸端溫度過高。 主軸端是一個集中部分,在高強度應力作用下,零件的使用壽命將大大削減。 因而,軸端密封,油封,滑動輪轂和旋轉輪轂中的密封及時替換; 主張將主軸端部的泄漏端側的軸承作為原始密封配件,以避免尺寸差異,磨損和損壞大軸及時查看光滑體系:
Due to the shaft end leakage and bearing wear caused by the conflict with the mixing shaft, the shaft end temperature is too high. The spindle end is a concentrated part. Under the action of high strength stress, the service life of parts will be greatly reduced. Therefore, the seals in shaft end seal, oil seal, sliding hub and rotating hub should be replaced in time
                 混凝土攪拌機廠家
1.光滑體系主油泵旋轉軸磨損現象
1. Wear phenomenon of rotating shaft of main oil pump in smooth system
2.光滑體系主油泵壓力表接口柱塞不能正常作業
2. The plunger at the pressure gauge interface of the main oil pump of smooth system cannot work normally
3.漸進式油分配器閥閥芯在光滑體系中阻塞,無法分配。
3. The valve core of progressive oil distributor safety valve is blocked in smooth system and cannot be distributed.
由于上述原因,軸端光滑體系呈現故障,需要替換光滑體系的主油泵。
Due to the above reasons, the smooth system at the shaft end presents a failure, and the main oil pump of the smooth system needs to be replaced.
如果你想做一個混凝土攪拌機,你應該從以下幾個方面入手:
If you want to make a concrete mixer, you should start from the following aspects:
1)整個混凝土攪拌機的成本操控。 這主要是指混凝土攪拌機,由于混凝土攪拌機的投入和出產本錢相對較低且易于辦理。
1) Cost control of the whole concrete mixer. This mainly refers to the concrete mixer, due to the concrete mixer input and production cost is relatively low and easy to handle.
2)細分整個混凝土攪拌機的出產過程,掌握每個細分出產過程的本錢。
2) Subdivide the production process of the whole concrete mixer, and master the cost of each subdivided production process.
3)做好整個混凝土攪拌機的出售計劃,制定相應的出產和出售計劃。
3) Do a good job of the whole concrete mixer sales plan, formulate the corresponding production and sales plan.
4)做好全站金融審計準則,確保整個資金鏈的有序發展。 主張是削減出售,而不是缺乏資金鏈。
4) Do a good job in the financial audit standards of the whole station to ensure the orderly development of the whole capital chain. The idea is to cut sales, not the lack of a capital chain.

截屏,微信識別二維碼