In the long-term use of mechanical equipment, in order to maintain its good operating performance, we need to lubricate it irregularly. So what should we pay attention to in the process of adding lubricating oil to the equipment?

1、攪拌一體機在運轉過程中不得檢修和潤滑。

1. It is not allowed to overhaul and lubricate the mixer during operation.

2、定期向各黃油嘴加注黃油，軸端密封處每4小時注潤滑油一次，每周排污一次。

2. Fill grease to each grease fitting regularly, fill lubricating oil into the shaft end seal every 4 hours, and drain water once a week.

3、攪拌一體機在使用后酌情對各潤滑點加注必要的潤滑油（滾輪軸、滾輪、鋼絲繩等活動部位）。

3. After use, add necessary lubricating oil (roller shaft, roller, wire rope and other moving parts) to each lubricating point as appropriate.

4、攪拌一體機減速箱的齒輪和軸承是利用齒輪回轉將機油飛濺到箱體內壁，流入軸承中去進行潤滑的。減速箱的油面應保持在油標尺兩刻線之間為宜。油面過高或過低會導致各部溫度升高或潤滑不良，增加功率損耗和造成機器工作不良。

4. The gear and bearing of the gearbox of the mixer are lubricated by splashing the oil on the inner wall of the box body and flowing into the bearing. The oil level of reducer should be kept between the two lines of oil scale. If the oil level is too high or too low, the temperature of each part will rise or the lubrication will be poor, the power loss will increase and the machine will work poorly.
                

5、攪拌一體機選用的潤滑油應具有一定購粘度和粘溫特性，凝點低，抗氧化安定性良好，沒有機械雜質和水分，不合腐蝕和磨損物質等。其質量指標應符合標準規定。

5. The lubricating oil selected for all-in-one mixer should have certain viscosity and viscosity temperature characteristics, low freezing point, good anti-oxidation stability, no mechanical impurities and moisture, no corrosion and wear substances, etc. The quality index should conform to the national standard.

攪拌一體機進行潤滑工作是為了能有效減少磨損，提高元部件的使用壽命。不過在進行添加潤滑油的過程中也要注意一些事項，新機開始使用頭150小時和300小時要分別更換機油一次，以便排除試車時未完全洗凈的污物。工作時，要經常檢查油面高度，不足應及時添補。

In order to reduce the wear and improve the service life of the components, the lubrication of the mixer is carried out. However, in the process of adding lubricating oil, we should also pay attention to some matters. In the first 150 hours and 300 hours of use of the new machine, the engine oil should be changed once, so as to remove the dirt that is not completely cleaned during the test run. When working, the height of oil level should be checked frequently, and the shortage should be supplemented in time.