The automatic feeding mixer is a common transport tool for concrete and clay. It should be ensured that there is no mistake during the transportation. The concrete and soil will be mixed in the whole process, so that the quality of concrete and clay can be maintained well until the destination is reached. The operation requirements of its hydraulic rotation system are as follows:

　　1、新車開始使用前，檢查和液壓系統各處的灰塵和雜物，并檢查各處連接是否正確和有無其它問題。

　　1. Before the new car starts to use, first check and remove the dust and debris around the hydraulic system, and check whether the connection is correct and whether there are other problems.

　　2、油箱中裝液壓油到油標刻度線以上，泵殼和馬達殼內也要充油。

　　2. The oil tank is filled with hydraulic oil above the oil mark, and the pump housing and motor housing should also be filled with oil.

　　3、啟動發動機，操縱伺服手柄使自動上料攪拌機拌筒在低速下正轉，觀察液壓系統是否正常工作。

　　3. Start the engine, operate the servo handle to make the mixing drum of automatic feeding mixer rotate forward at low speed, and observe whether the hydraulic system works normally.
                

　　4、油溫不得超過60℃，泵殼壓力必須小于0.25MPa。

　　4. The oil temperature should not exceed 60 ℃, and the pump shell pressure must be less than 0.25MPa.

　　5、注意散熱器上的風扇在50℃-70℃范圍內應是運轉狀態。風扇發生故障不運轉時，應及時修理。

　　5. Note that the fan on the radiator should be in operation state within the range of 50 ℃ - 70 ℃. When the fan fails to work, it should be repaired in time.

　　6、補油泵溢流閥、低壓溢流閥、高壓溢流閥壓力出廠時已調定，不得隨意改動。

　　6. The pressure of relief valve, low-pressure relief valve and high-pressure relief valve of make-up oil pump has been set before delivery and shall not be changed at will.

　　7、自動上料攪拌機油路中各部件及管路不得有漏油現象，如發生滲漏，應及時修理。

　　7. There shall be no oil leakage in the parts and pipelines of the automatic feeding and mixing oil pipeline. In case of leakage, it shall be repaired in time.

　　8、工作運轉狀態時，不得隨意修理和調整。

　　8. It is not allowed to repair and adjust at will when working.

　　9、液壓油泵、馬達若發生故障需及時更換下來送指定維修部修理。

　　9. If the hydraulic oil pump and Mada fail, they should be replaced in time and sent to the professional designated maintenance department for repair.

　　我們在駕駛自動上料攪拌機的時候應該做好各個方面的檢查，液壓轉動系統對于整個攪拌車來說是很關鍵的一部分，液壓轉動系統符合使用要求才能率使用攪拌車。

　　We should do a good job in all aspects of the inspection when driving the automatic feeding mixer. The hydraulic rotation system is a key part of the whole mixer. Only when the hydraulic rotation system meets the requirements can we use the mixer efficiently.