Under a certain pressure, the small concrete transportation mixer has the effect of pressure, which will produce certain power and start its operation. In this way, the concrete above can be mixed more fully. Under the premise of insufficient pressure, the efficiency of mixer may be affected. How to deal with the lack of pressure?

　　1、查看小型混凝土運輸攪拌機液壓泵是否能輸出液壓油。如果是新的液壓泵，無液壓油輸出，可能是泵體有鑄造缺陷(縮孔、砂眼等)，使吸油腔和壓油腔相通，失去壓油能力，應及時找廠家更換。若不是新的液壓泵，無液壓油輸出，可能是泵的轉向不對，零件磨損嚴重或損壞，及時更換。

　　1. Check whether the hydraulic pump of small concrete transportation mixer can output hydraulic oil. If the oil cavity and oil cavity of the pump are connected to each other in time, it is necessary to replace the oil pump with a new one. If it is not a new hydraulic pump and there is no hydraulic oil output, it may be that the steering direction of the pump is not correct and the parts are seriously worn or damaged. Replace them in time.

　　2、若小型混凝土運輸攪拌機液壓泵有油液輸出，查看溢流閥工作是否正常。若不正常，則可能是壓力油路中的某個閥有污物或其他原因卡住，處于回油位置，致使壓力油路與溢流回路短路，也可能是管接頭松脫，或處于壓力油路中的某些閥泄漏嚴重，或液壓缸、液壓馬達的密封損壞，嚴重泄漏。排除方法是拆開有關閥進行清洗，檢查密封間隙的大小及各種密封裝置，密封裝置損壞應更換。

　　2. If the hydraulic pump of small concrete transportation mixer has oil output, check whether the relief valve works normally. If it is abnormal, it may be that a valve in the pressure oil circuit is stuck due to dirt or other reasons, and it is in the oil return position, resulting in a short circuit between the pressure oil circuit and the overflow circuit, or the loose pipe joint, or serious leakage of some valves in the pressure oil circuit, or the seal damage of the hydraulic cylinder and hydraulic horse. The elimination method is to remove the relevant valve for cleaning, check the size of sealing clearance and various sealing devices, and replace the sealing device if it is damaged.
                

　　3、若水泥小型混凝土運輸攪拌機的液壓泵輸出流量隨壓力升高而顯著減小，且壓力達不到規定值，則是由于液壓泵磨損后間隙增大所致。排除方法是測定液壓泵的容積效率，即可確定該泵是否能繼續使用，對磨損嚴重的零件，應進行修配或更換。

　　3. If the output flow of the hydraulic pump of the small cement concrete transportation mixer decreases significantly with the increase of the pressure, and the pressure can not reach the specified value, it is due to the increase of the clearance after the hydraulic pump is worn. The elimination method is to measure the volumetric efficiency of the hydraulic pump, so as to determine whether the pump can continue to be used. The parts with serious wear should be repaired or replaced.

　　4、小型混凝土運輸攪拌機的液壓系統能建立正常壓力，而某些管路或液壓缸中無壓力，可能是由于管路、小孔或節流閥、換向閥等部位堵塞。此時應逐段檢查壓力和有無油液通過，找出原因，加以排除。

　　4. The hydraulic system of small concrete transportation mixer can establish normal pressure, but there is no pressure in some pipelines or hydraulic cylinders, which may be due to blockage of pipelines, orifices, throttle valves and directional valves. At this time, check the pressure and whether there is oil passing through section by section, find out the reason and eliminate it.

　　根據小型混凝土運輸攪拌機壓力不足的原因，應該及時更換一些配件，做好調整。將壓力恢復到正常情況。按照以上方法進行操作，能夠適當提高攪拌機的壓力，及時壓力不足的問題。

　　According to the reason of insufficient pressure of small concrete transportation mixer, some accessories should be replaced in time and adjusted well. Return the pressure to normal. According to the above methods, the pressure of the mixer can be properly increased and the problem of insufficient pressure can be solved in time.