I believe that some merchants who use automatic feeding mixer equipment know that there will be some sudden failures in the long-term use of the equipment. When the equipment fails to operate normally, how to clean the materials remaining in the mixing tank? Let's introduce it.

1、準備好緊急驅動軟管，將攪拌機熄火，卸下液壓馬達上的高壓油管接頭。

1. Prepare the emergency drive hose, turn off the mixer, and remove the high-pressure oil pipe connector from the hydraulic motor.

2、將救援車熄火，將其液壓馬達的高壓油管卸下，并與故障車上的對應接頭用緊急驅動軟管相連。

2. Turn off the rescue vehicle, remove the high-pressure oil pipe of its hydraulic motor, and connect it with the corresponding connector on the faulty vehicle with emergency drive hose.
                

3、發動救援車，將其操縱手柄撥出料位置，故障車內的混凝土即被排出。

3. Start the rescue vehicle and turn its control handle to the discharging position, then the concrete in the failure vehicle will be discharged.

4、緊急驅動完畢后，將驅動軟管卸下，并恢復兩車原狀。

4. After the emergency drive, remove the drive hose and restore the two vehicles to their original state.

除了上述方式之外，在自動上料攪拌機托輪和滾道之間放入木楔，以控制攪拌筒的旋轉，一定要注意；將發動機熄火，拆松液壓馬達的一根高壓油管，攪拌筒可自由旋轉，控制攪拌筒的旋轉，使維修孔轉到下部，然后打開維修孔，清理出筒內混凝土。此時一定要注意，混凝土排出完畢后，恢復攪拌機原狀。

In addition to the above methods, put a wedge between the roller and the raceway of the automatic feeding mixer to control the rotation of the mixing drum, and pay attention to safety; turn off the engine, loosen a high-pressure oil pipe of the hydraulic motor, and the mixing drum can rotate freely, control the rotation of the mixing drum, turn the maintenance hole to the lower part, and then open the maintenance hole to clean out the concrete in the drum. At this time, we must pay attention to safety. After the concrete is discharged, the mixer shall be restored to its original state.