關于自動上料攪拌機配料機組的標定。在使用過程中應重視配料機組的校準工作。對于同一臺配料機，不同規格的骨料、不同的料門開度都有不同的標定系數。因此，在更換骨料規格和調整料門開度時，都必須重新校準相應于該配料機的標定系數。特別是在使用之始，更應重視配料機的標定工作。

About the calibration of automatic feeding mixer batching unit. In the process of using, we should pay attention to the calibration of batching unit. For the same batching machine, there are different calibration coefficients for different specifications of aggregate and different opening of material door. Therefore, it is necessary to recalibrate the calibration coefficient corresponding to the batching machine when changing the aggregate specifications and adjusting the opening of the material door. Especially at the beginning of use, more attention should be paid to the calibration of batching machine.

自動上料攪拌機的配料機組要經常保持各配料機中骨料規格的一致。骨料規格的不一致不會影響混合料級配的波動，而且會嚴重影響到混合料的性能。因此應嚴格加強料堆管理，防止發生混放；同時，裝載機手要仔細操作，防止發生混倉。

The batching unit of the automatic feeding mixer should always keep the aggregate specifications in each batching machine consistent. The inconsistency of aggregate size will not affect the fluctuation of mixture gradation, and will seriously affect the performance of mixture. Therefore, it is necessary to strengthen the management of stockpiles to prevent the occurrence of mixing; At the same time, the loader hand should operate carefully to prevent mixing.
           

自動上料攪拌機開機前，應按下“開機警告”按鈕，以示告警，室外電鈴響過幾次后，并確定不會有危險發生時再行開機，也可通過擴聲器予以警告。正常生產中，偶遇緊急情況也可通過此種方式予以警告。設備拌制出的穩定土混合料（成口的配比及含水率，可采用取樣分析的辦法進行確定，然后根據分析的結果，再次對各配料機及供水流量進行的調整。

Before starting the automatic feeding mixer, the "start warning" button should be pressed to show the alarm. After the outdoor electric bell rings several times and it is determined that there will be no danger, the mixer can be started again, or the alarm can be given through the loudspeaker. In normal production, in case of emergency, warning can also be given in this way. The proportion and moisture content of the stabilized soil mixture (finished) mixed by the equipment can be determined by sampling analysis, and then the batching machine and water supply flow can be adjusted again according to the analysis results.

自動上料攪拌機投入正常運行時，應配備三名熟練的工作人員，一人在控制臺負責整套設備運轉的操作，另外二人進行設備運行情況、物料的配給及供料狀況的巡視工作，并為保證皮帶機的對中運行隨時監測、調整。發現問題及時協調或通知操作人員進行停機處理。

When the automatic feeding mixer is put into normal operation, three skilled workers should be equipped. One is responsible for the operation of the whole set of equipment on the console, and the other two are responsible for the inspection of equipment operation, material distribution and feeding condition, and monitoring and adjusting the belt conveyor at any time to ensure the centering operation. If any problem is found, coordinate and solve it in time or inform the operator to stop the machine.