1.在施工現(xiàn)場卸載后，立即用連接在攪拌車上的軟管沖洗進料斗，出料斗和卸料斜槽，以除去附著在車身上的淤泥和混凝土。在返回攪拌站的途中，應將150-200 L的水倒入攪拌桶中，以清洗墻壁和葉片上的混凝土殘渣。

1. After unloading at the construction site, immediately flush the feed hopper, discharge hopper and discharge chute with the hose connected to the mixer truck to remove the sludge and concrete attached to the truck body. On the way back to the mixing plant, 150-200 l of water should be poured into the mixing drum to clean the concrete residue on the walls and blades.

2.每天工作后，駕駛員向混合桶中注入清水，以高速（14-18 rpm）旋轉5-10分鐘，然后排干水以確保桶是干凈的。用高壓水清潔混合槽的每個部分時，請注意不要觸摸儀器或操縱桿。壓力水噴嘴與噴漆主表面之間的距離必須少為40 cm。

2. After working every day, the driver injects fresh water into the mixing bucket, rotates at high speed (14-18 RPM) for 5-10 minutes, and then drains the water to ensure that the bucket is clean. When cleaning each part of the mixing tank with high-pressure water, be careful not to touch the instrument or the control lever. The distance between the pressure water nozzle and the main painting surface must be at least 40 cm.
                     

3.在清潔混合槽內外的污垢和殘留的混凝土渣時，以及當技工進入混合槽進行維護或焊接維修工作時，需要停止汽車發(fā)動機并完全停止混合槽。當技工進入氣瓶工作時，他需要確?；旌蠚馄客L良好，空氣新鮮，沒有氣體或有害的粉塵以及氧氣供應充足。在桶中使用電動工具時，操作員必須具有良好的絕緣保護。

3. When cleaning the dirt and residual concrete slag inside and outside the mixing tank, and when the technician enters the mixing tank for maintenance or welding repair, it is first necessary to stop the car engine and completely stop the mixing tank. When the mechanic enters the cylinder to work, he needs to ensure that the mixing cylinder is well ventilated, the air is fresh, there is no gas or harmful dust, and the oxygen supply is sufficient. When using power tools in barrels, the operator must have good insulation protection.

4.工作時請勿觸摸旋轉的攪拌桶。嚴禁觸摸和混合主出料槽和擴展出料槽之間的連接。清潔攪拌桶時應注意什么？為避免發(fā)生事故。

4. Do not touch the rotating mixing bucket when working. Do not touch and mix the connection between the main discharge chute and the extended discharge chute. What should be paid attention to when cleaning the mixing bucket? To avoid accidents.