自動上料攪拌機行駛過程中，“慢”字是一個。轉彎時一定要慢。攪拌車高，容易翻車！進彎前要減速降檔，過彎時盡量不要猛踩剎車。隨時通過后視鏡，注意觀察罐子是否在轉動，盡量調慢速度。因?yàn)樗俣忍?，攪拌車容易擺動。滿載時，走到大傾角路段時，先停罐。攪拌車高，停止罐體轉動有利于保證車輛的穩定性。

"Slow" is a key word in the driving process of automatic feeding mixer. Be sure to turn slowly. The mixer truck has a high center of gravity and is easy to overturn! Slow down and downshift before entering the corner, and try not to slam on the brake when crossing the corner. Through the rearview mirror at any time, pay attention to observe whether the can is rotating and slow down as much as possible. Because the speed is too high, the mixer truck is easy to swing. When fully loaded, stop the tank first when walking to the section with large inclination angle. The center of gravity of the mixer truck is high, and stopping the rotation of the tank is conducive to ensuring the stability of the vehicle.

在糟糕的道路上，使用合適的低檔超車。遇到不平路面、坑洼等情況，使用合適的低速檔位通過，保證車子隨時有爆發力。應盡可能避免使用木板和鋒利的石頭！

On bad roads, use the right low gear to overtake. In case of uneven roads, potholes and other situations, use the appropriate low-speed gear to ensure that the car has explosive power at any time. Boards and sharp stones should be avoided as far as possible!

上坡時建議是提前降檔。如果攪拌車滿了，要注意輕緩起步，上坡時要多加注意。你不應該隨意降檔，所以你可以提前降檔。下坡時不要將重型車輛滑入空檔。習慣在長時間駕駛或下坡之前測試剎車。不要在重型車輛掛空檔時滑下坡。下坡轉彎時，提前減速，然后降檔再減速。帶檔制動效果好。

When going uphill, it is recommended to downshift in advance. If the mixer truck is full, pay attention to starting gently and pay more attention when going uphill. You shouldn't downshift at will, so you can downshift in advance. Do not slide heavy vehicles into neutral when going downhill. Get used to testing the brakes before driving for a long time or going downhill. Do not slide downhill when heavy vehicles are in neutral. When turning downhill, slow down in advance, then downshift and then slow down. Good braking effect with gear.

注意高度限制。施工現場路況復雜，注意樹木等，尤其要防止劃傷電線。此外，攪拌車進入工地時要多加注意一些事項，比如說：

Pay attention to the height limit. Pay special attention to the complex construction conditions, such as trees, wires, etc. In addition, pay more attention to some matters when the mixer truck enters the construction site, such as:

進入工地時，盡量走在中間。工地道路簡單，路基松軟?，F(xiàn)在水泥攪拌車已經達到10多。如果他們靠近路邊行駛，道路很容易被碾壓塌陷，導致車輛翻車。

When entering the construction site, try to walk in the middle. The site road is simple and the subgrade is soft. Now the cement mixer has reached more than 10 square meters. If they drive close to the roadside, the road is easy to be crushed and collapsed, resulting in vehicle rollover.

提前下車檢查倒車線。許多攪拌車在夜間工作。到達工地后，下車拿電筒查看倒車路線。如有障礙物、坑洼或比較松軟的地方，記得及時清理鋼釘?shù)取?/div>