攪拌機重新投入使用前要檢查的十件事
來源：http://www.wishnailspa.com/日期：2022-06-06
概述：1、檢查機油、柴油、轉向油、離合器油、剎車油和發動機冷卻液的加注情況，確保車輛正常使用，并更換和清洗機油濾清器、柴油機及時過濾和空
1、檢查機油、柴油、轉向油、離合器油、剎車油和發動機冷卻液的加注情況，確保車輛正常使用，并更換和清洗機油濾清器、柴油機及時過濾和空氣過濾器。
1. Check the filling of engine oil, diesel, steering oil, clutch oil, brake oil and engine coolant to ensure the normal use of the vehicle, and replace and clean the engine oil filter, diesel engine timely filter and air filter.
2、檢查轉向系統、離合器、制動系統是否工作正常。檢查照明、報警器、方向燈、剎車燈、雨刮器等工作是否正常，并進行清潔。檢查輪胎氣壓是否正常，是否有裂紋或損壞，輪胎螺母是否松動。
2. Check whether the steering system, clutch and braking system work normally. Check whether the lighting, alarm, direction light, brake light, wiper, etc. work normally and clean them. Check whether the tire pressure is normal, whether there is crack or damage, and whether the tire nut is loose.
3、檢查完畢后，啟動車輛暖機，檢查油壓、發動機水溫是否正常，底盤氣路是否漏氣。
3. After the inspection, start the vehicle to warm up, check whether the oil pressure and engine water temperature are normal, and whether the chassis air circuit leaks.
4、用尿素檢查車輛。發動機關閉少30秒后，請勿關閉車輛主電源。此時系統會將殘留的尿素溶液從管道中排出，防止結晶物堵塞噴嘴。
4. Check the vehicle with urea. Do not turn off the main power supply of the vehicle after the engine has been turned off for at least 30 seconds. At this time, the system will discharge the residual urea solution from the pipe to prevent the crystal from blocking the nozzle.
5、檢查混凝土攪拌機的液壓泵、電機、減速機是否漏油，液壓油、減速機齒輪油是否充足，是否有變質，液壓油濾芯是否符合使用要求，液壓油散熱器是否能工作一般。
5. Check whether the hydraulic pump, motor and reducer of the concrete mixer leak oil, whether the hydraulic oil and reducer gear oil are sufficient and deteriorated, whether the hydraulic oil filter element meets the use requirements, and whether the hydraulic oil radiator can work normally.
6、檢查主副車架的連接螺栓是否松動、脫落；副車架和底盤橫梁是否開裂。
6. Check whether the connecting bolts of the main and subframe are loose and fall off; Whether the subframe and chassis crossmember are cracked.
7、檢查滾道和托輥表面是否有異物，及時；轉動攪拌筒，檢查是否有晃動、異響等；檢查托輥的緊固螺栓是否松動，托輥是否移位；支撐輥的內側。
7. Check whether there are foreign matters on the surface of the raceway and idler, and remove them in time; Rotate the mixing drum to check whether there is shaking, abnormal noise, etc; Check whether the fastening bolts of the idler are loose and whether the idler is displaced; Inside of support roll.
8、檢查進料斗、溜槽有無結塊并；溜槽伸縮支架轉動時，檢查伸縮支架是否正常膨脹，并在伸縮支架和支撐搖桿上加注潤滑脂。
8. Check whether the feeding hopper and chute are caked and remove them; When the chute telescopic support rotates, check whether the telescopic support expands normally, and fill the telescopic support and the support rocker with grease.
9、檢查傳動軸的連接螺栓是否松動，并在傳動軸的花鍵和橫軸上加注潤滑脂。
9. Check whether the connecting bolts of the transmission shaft are loose, and add grease to the splines and horizontal shafts of the transmission shaft.
10、檢查
混凝土攪拌機的旋轉控制手柄的操作是否卡住，并在油嘴內加注潤滑脂。
10. Check whether the operation of the rotary control handle of the concrete mixer is stuck, and fill the grease in the nozzle.
以上是攪拌機重新投入使用前要檢查的十件事的相關內容，希望能幫助到你。更多相關內容就來我們網站
www.zkhntjbc.com進行咨詢了解吧！
The above is the relevant content of the ten things to check before the mixer is put into use again. I hope it can help you. For more information, please visit our website at www.zkhntjbj Www. 68mn. Com!
全國服務熱線
點擊撥打服務熱線：400-879-1999
