在設備實際操作運行過程中，攪拌一體機的變速器是一個非常重要的部件。因此，我們在使用過程中對其油質需要有一定的檢測工作，那么我們具體應該怎么進行操作呢？

In the actual operation process of the equipment, the transmission of the mixer is a very important part. Therefore, we need to test the oil quality in the process of use, so how should we operate?

1、將攪拌一體機停放在水平地面上，并拉緊手制動。

1. Park the mixer on the horizontal ground and tighten the hand brake.

2、讓發動機怠速運轉數分鐘。

2. Let the engine idle for a few minutes.

3、踩住制動踏板，將操縱手柄撥倒擋、前進擋等位置，并在每個擋位上停留幾秒鐘，使液力變矩器和所有換擋執行元件中都充滿液壓油。然后將操縱手柄撥停車擋位置。

3. Step on the brake pedal, turn the control handle to the reverse gear, forward gear and other positions, and stay in each gear for a few seconds, so that the hydraulic torque converter and all shift actuators are filled with hydraulic oil. Then turn the joystick to the park position.
               

4、從加油管內撥出自動變速器油尺，將擦干凈的油尺全部插入加油管再拔出，檢查油尺上的油面高度。

4. Pull out the automatic transmission oil dipstick from the oil filling pipe, insert all the cleaned oil dipstick into the oil filling pipe, and then pull it out to check the oil level on the oil dipstick.

在對攪拌一體機變速器進行檢查或故障診斷前，要對變速器油面和油質進行檢查。把選擋手柄放在P位，將發動機在怠速時少運轉數分鐘，油液達到正常工作溫度，汽車必須停放在水平路面上，這樣才能確保在差速器和變速器之間的油面高度正常、穩定。

Before the inspection or fault diagnosis of the transmission of the mixer, the oil level and quality of the transmission should be inspected first. Put the gear selection handle in position P, run the engine at idle speed for at least a few minutes, the oil reaches the normal working temperature, and the car must be parked on the horizontal road, so as to ensure the normal and stable oil level between the differential and the transmission.