The brake system of the mixer is very important for the concrete mixer, so it is necessary for us to master some brake knowledge of the vehicle and four brake methods of the mixer.

1.點剎，是很多司機都知道的制動方法，一般在攪拌機遇到緊急情況時，猛踩剎車是非常不理智的行為，很容易發生危險的，此時應該先輕點剎車，再放開，再輕點，再放開，讓車速逐漸降低，這種方法通常在雨天或冰雪路面上使用，可以防止車輛跑偏或側滑。

1. Point brake is a braking method known to many drivers. Generally, when the mixer encounters an emergency, it is very irrational to step on the brake. It is easy to be dangerous. At this time, you should first light the brake, then release it, then light it, and then release it, so as to gradually reduce the speed. This method is usually used in rainy days or ice and snow roads, which can prevent the vehicle from deviation or sideslip.

2.緊急制動，當攪拌機在行駛的過程中遇到緊急情況是，駕駛員應迅速放松油門踏板，用力踩下剎車，同時拉緊手剎，盡可能在短距離內將車輛停住，以達到避免事故的目的，這種方法是不得已的情況下采取的緊急措施，因為它對車輛的輪胎和各個部件是有損害的，同時制動時的方向已經不能控制，所以應該盡量避免這種制動。

2. Emergency braking: when the blender encounters an emergency in the process of driving, the driver should quickly relax the accelerator pedal, step on the brake, and tighten the handbrake at the same time to stop the vehicle in a short distance as far as possible, so as to avoid accidents. This method is an emergency measure taken as a last resort, because it damages the tires and various parts of the vehicle At the same time, the direction of braking can not be controlled, so this kind of braking should be avoided as far as possible.
               

3.先急后松，這種方法就是在遇到緊急情況時，先急踩剎車接著要緩沖一下再踩剎車，然后根據發生情況點的距離慢慢松開制動踏板，再更換與速度匹配的檔位，正常行駛即可。這種方法可以大大降低由車速急劇變化帶來的沖擊，使車輛運行穩定。

3. Emergency first and then release. This method is that in case of emergency, first step on the brake, then cushion it, and then step on the brake, then release the brake pedal slowly according to the distance of the occurrence point, and then change the gear matching the speed, and drive normally. This method can greatly reduce the impact caused by the rapid change of vehicle speed and make the vehicle run stably.

4.預見性制動，這種方法主要就是在司機開車過程中，對道路上的車輛、行人、非機動車的變化，做預見性的制動，具體做法就是將腳放開油門踏板，利用發動機怠速時的牽阻力作用來降低車速，然后根據具體情況繼續減速或者輕踏油門，讓車輛平穩的減速或者停車，這種方法能有效保證行車，降低車輛零部件的損害程度，這種制動方法在平時使用的比較多，也比較普遍的。

4. Predictive braking, this method is mainly in the driver's driving process, on the road vehicles, pedestrians, non motor vehicle changes, do predictive braking, the specific method is to let the foot off the accelerator pedal, use the engine idle drag effect to reduce the speed, and then according to the specific situation continue to slow down or tap the accelerator, let the vehicle slow down or stop smoothly This method can effectively ensure the driving safety and reduce the damage degree of vehicle parts. This braking method is widely used in daily life.

由于攪拌一體機車身比較重，在平時的行車過程中對車輛的制動更應該要注意，多知道一些車輛的制動方法，在行車的路上就多了一份保障！

Due to the heavy body of the mixer, we should pay more attention to the braking of the vehicle in the normal driving process. If we know more about the braking methods of some vehicles, we will have more security on the road!