1. The negative machine completely loads the bearing, so good smoothness is the main factor of bearing life. It directly affects the service life and normal operation time of the machine. Therefore, it is necessary to clean the injected oil. The primary oil injection point (1) rolling bearing (2) rolling bearing (3) movable bearing of all gears (4) of this machine should be well sealed.

2.新設備的車輪容易松動，應經常檢查。

2. The wheels of new equipment are easy to loosen, so they should be checked frequently.

3.注意機器的各個部分是否正常工作。

3. Pay attention to whether all parts of the machine work normally.

4.注意磨損零件的磨損程度，并隨時更換磨損零件。

4. Pay attention to the wear degree of worn parts and replace worn parts at any time.
                      

5.放置移動設備的機架平面上的灰塵和其他灰塵，以防止當機器遇到堅不可摧的材料而造成嚴重事故時，可移動軸承在機架上移動。您需要確保沒有對象。

5. Dust and other dust on the plane of the rack of the mobile equipment, so as to prevent the movable bearing from moving on the rack when the machine encounters indestructible materials and causes serious accidents. You need to make sure there are no objects.

6.必須升高軸承油的溫度并立即停車以確認原因并。

6. The temperature of bearing oil must be raised and the machine must be stopped immediately to confirm the cause and eliminate it.

7.如果在滾動齒輪工作時發生碰撞，應立即停放，檢查并碰撞。

7. If there is a collision when the rolling gear is working, it should be stopped immediately to check and eliminate the collision.