自動上料攪拌機易堵部位的排除方法
來源：http://www.wishnailspa.com/日期：2022-08-01
概述：在施工時如果按照正規的操作流程，使用較好的混凝土材料。如果自動上料攪拌機發生堵管現象，檢查容易發生堵管的兩個部位，就可以排除障礙。
在施工時如果按照正規的操作流程，使用較好的混凝土材料。如果自動上料攪拌機發生堵管現象，檢查容易發生堵管的兩個部位，就可以排除障礙。下面來講講
自動上料攪拌機易堵部位的排除方法吧。
During construction, if the normal operation process is followed, better concrete materials shall be used. If the automatic feeding mixer has pipe blockage, check the two parts that are prone to pipe blockage, and the obstacles can be eliminated. Now let's talk about the elimination methods of the easily blocked parts of the automatic feeding mixer.
管閥
Pipe valve
管閥處堵塞通常是逐漸形成的，其主要原因是自動上料攪拌機在攪拌完混凝土后，沒有及時用高壓水予以沖洗，導致混凝土殘留在管內。隨著時間的增加，殘?jiān)饾u加厚，堆積固結終導致堵塞。
The blockage at the pipe valve is usually formed gradually. The main reason is that the automatic feeding mixer does not wash the concrete with high-pressure water in time after mixing the concrete, resulting in the residual concrete in the pipe. With the increase of time, the residue gradually thickened, accumulated and consolidated, and finally led to blockage.
為了避免這種攪拌機堵管狀況，可以在每次攪拌混凝土結束后，用高壓水將自動上料攪拌機體和管沖洗干凈。如果沖洗無效，那么可以采用釬敲的方法把殘?jiān)サ?，直到清理干凈為止?/div>
In order to avoid this kind of mixer pipe blockage, the automatic feeding mixer body and pipe can be washed with high-pressure water after each mixing of concrete. If the flushing is ineffective, the residue can be removed by drilling until it is cleaned.
配閥出料口
Valve outlet
配閥出料口處的堵塞行為，一般發生在自動上料攪拌機的連續上料機送系統動作突然中斷的狀況下，這種情況一般會有異常聲響出現，同時設備會出現較強振動，但管道內不會有相應振動。
The blocking behavior at the discharge port of the distribution valve usually occurs when the continuous feeding system of the automatic feeding mixer is suddenly interrupted. In this case, there will be abnormal sound and strong vibration of the equipment, but there will be no corresponding vibration in the pipeline.
一旦發生這種上料機攪拌機堵管現象，可以采取往料斗內倒入水泥漿的方法，然后反復正、反向啟動連續上料機，迫使通路打開。如果這種方法沒有效果，那就只能進行人工排除，人工排除需要拆下相連管，然后去掉攪拌機閥內的雜物。
Once this kind of pipe blockage occurs in the mixer of the feeding machine, the method of pouring cement slurry into the hopper can be adopted, and then the continuous feeding machine can be started repeatedly in the forward and reverse directions to force the channel to open. If this method is ineffective, it can only be manually eliminated. Manual elimination requires removing the connecting pipe and then removing the sundries in the mixer valve.
The elimination method of the easily blocked part of the automatic feeding mixer is explained from two aspects. You should pay attention to maintenance during daily construction, so as to better use. Pay attention to our website http://www.wishnailspa.com Learn more.
全國服務熱線
點擊撥打服務熱線：400-879-1999
