How to repair the engine according to the manufacturer's analysis of the automatic charging mixer?

一，氣缸的內徑過度磨損。圓度偏差為0.040.06 mm，圓柱度偏差為0.080.12 mm（通常測量圓柱體下半部和上半部之間的差）。對于多缸發動機，圓度和圓柱度之間的偏差基于具有高磨損的氣缸。

1、 The inner diameter of the cylinder is excessively worn. The roundness deviation is 0.04 to 0.06 mm and the cylindricity deviation is 0.08 to 0.12 mm (the difference between the lower and upper half of the cylinder is usually measured). For multi cylinder engines, the deviation between roundness and cylindricity is based on the cylinder with high wear.

其次，機油量顯著增加，機油壓力下降，黑色和藍色的煙霧從排氣管排出。

Secondly, the amount of oil increases significantly, the oil pressure decreases, and black and blue smoke is discharged from the exhaust pipe.

第三，自動上料攪拌機的功率已大大降低。它的高功率僅約為額定功率的60％（不包括由于高海拔引起的功率損失），其氣缸壓力小于標準壓力的65％。

Third, the power of the automatic feeding mixer has been greatly reduced. Its high power is only about 60% of the rated power (excluding power loss due to high altitude), and its cylinder pressure is less than 65% of the standard pressure.
            

第四，曲軸磨損太大，軸磨損超過使用極限后曲軸的圓度和圓柱度偏差，或者圓度和錐度限制在0.10 mm。

Fourth, the crankshaft wear is too large, and the roundness and cylindricity deviation or roundness and taper are limited to 0.10 mm after the shaft wear exceeds the service limit.

第五，當發動機啟動或停止時，如果水溫為50 ^ -60°C，水溫將無法平穩啟動。

Fifth, when the engine starts or stops, if the water temperature is 50 ^ - 60 ° C, the water temperature will not start smoothly.

第六，發動機異?；虍惓！．?dāng)發動機在高溫下運行時，氣缸中會產生噪音（活塞爆震），并且主軸承和連桿軸承會產生劇烈的振動和爆震噪音。

Sixth, the engine is abnormal or abnormal. When the engine is running at high temperature, there will be noise in the cylinder (piston knock), and the main bearing and connecting rod bearing will produce violent vibration and knock noise.

以上是自動上料攪拌機廠家修理發動機的相關內容，希望對大家有所幫助，想要了解更多內容歡迎點擊我們的自動上料攪拌機http://www.wishnailspa.com網站。

The above is the automatic feeding mixer manufacturers repair engine related content, hope to help you, want to learn more, welcome to click our automatic charging mixer http://www.wishnailspa.com Website.