早上，當攪拌一體機冷啟動時，注意檢查排氣管的出口。如果剛剛啟動時排氣管冒出藍煙，說明攪拌機在燒油。這種方法很好由兩個人來完成，一個是啟動攪拌機，另一個是負責調查。因?yàn)樗{(lán)煙的時間很短，只有在攪拌機放置較長時間后才會出現。

In the morning, when the all-in-one mixer is cold started, pay attention to check the outlet of the exhaust pipe. If the exhaust pipe emits blue smoke when it is just started, it indicates that the mixer is burning oil. This method is well done by two people, one is to start the mixer, the other is responsible for the investigation. Because the time of blue smoke is very short, it will appear only after the mixer is placed for a long time.

當油門開高時，會冒出藍煙。當攪拌機快速加速或?qū)⒓铀倨鞔档竭m當位置時，會發出藍煙，但不是在怠速下。這種情況說明攪拌機燒機油，現在很嚴重，應該盡快修理。

When the throttle is turned high, blue smoke will appear. When the mixer accelerates rapidly or the accelerator is blown to the appropriate position, blue smoke will be emitted, but not at idle speed. This situation shows that the mixer burns oil, which is very serious now, and it should be repaired as soon as possible.

攪拌機的機油入口冒出藍煙。除排氣口外，攪拌機的發動機進油口還冒出藍煙。經查明，癥狀已到中晚期，機油燃燒十分嚴重。必須盡快送去修理，以免造成更大的損壞。

Blue smoke came from the oil inlet of the mixer. In addition to the exhaust port, the engine oil inlet of the mixer also emits blue smoke. After investigation, the symptoms have reached the middle and late stage, and the engine oil combustion is very serious. It must be sent for repair as soon as possible so as not to cause greater damage.

攪拌一體機筒體密封性差是造成燃油燃燒的主要原因。主要原因是活塞與缸壁間隙過大，活塞環安裝不當或密封性差，缸壁上的油進入燃燒室，造成油燃燒。

The poor sealing of the mixing machine cylinder is the main reason for fuel combustion. The main reasons are that the clearance between the piston and the cylinder wall is too large, the piston ring is improperly installed or the sealing is poor, and the oil on the cylinder wall enters the combustion chamber, causing oil combustion.

如何攪拌車燃油燃燒問題？盡量選用機油。舊混凝土攪拌車可以使用粘度稍高的機油來增加活塞與筒壁之間的密封。礦物發動機油使用時間長，使用全組分發動機油后容易出現密封不嚴的情況。

How to solve the fuel burning problem of mixer truck? Try to use high-quality engine oil. The oil with slightly higher viscosity can be used in the old concrete mixer to increase the sealing between the piston and the cylinder wall. Mineral engine oil has been used for a long time, and it is prone to loose sealing after using full component engine oil.

經常檢查攪拌一體機的油垢，定期更換攪拌機的油和濾油器，更換原裝濾油器的備件，選用原廠的油等，可避免攪拌機的燒油現象。

Regularly check the oil dirt of the mixer, regularly replace the oil and oil filter of the mixer, replace the spare parts of the original oil filter, and select the original oil, etc., so as to avoid the oil burning phenomenon of the mixer.

檢查攪拌一體機的油耗有判斷方法便是以上講解了，您可以作為參考使用，當然也要注意一些事項，防止有意外發生，更多內容就來網站http://www.wishnailspa.com咨詢看看吧。

There are ways to check the fuel consumption of the mixing machine, which is explained above. You can use it as a reference. Of course, you should also pay attention to some matters to prevent accidents. For more information, please visit the website http://www.wishnailspa.com Consult and have a look.